Is there a 3D Brothers edition of electrodacus sbms40?

I’ve received one of the new “3D brothers edition” Electrodacus SBMS40s from the prototype batch, as offered forum members for review purposes recently by Alex Gradea.

Are electrodacus sbms40/60/100/120 batteries prone to a failure mode?

The Electrodacus SBMS40/60/100/120 models, incorporating the switching electronics in the control unit, are susceptible to such a failure mode - those units must first have both PV and load removed before they can be disconnected from the battery.

How does electrodacus work?

n also create excess heat.ElectroDacus takes a different approach, by providing on/off signals to the ba ery’s inputs and loads. When the battery gets full, it switches off the charging sources, and if the battery gets low, t switches off any draws. The switching function is customizable, with multiple input/output ports, a

Why is my electrodacus not balancing?

So you need to cycle power on the BMS to get whatever that flag is cleared and the updated parameters saved in the BMS chip. If you don't do this after changing Parameter Settings or Advanced Parameter Settings, the Electrodacus won't balance.

How do I Reset my electrodacus SoC?

Then Save Device settings (on the first page). To reset the SOC, you have to run the voltage up to 14.2 to get the Electrodacus to initialize the State of Charge to 100%, then it uses the measured current flow into and out of the battery to keep track of the SOC (NOT the battery voltage).

What happens if I power cycle the electrodacus?

When you do power cycle the Electrodacus, it loses your state of charge, and the time/date, and it also re-calibrates the shunts (why you want all current flow off). Go into Device Settings, press set key twice, and you can change the date/time. Then Save Device settings (on the first page).